I can take metal off quickly, but putting it back on would be very difficult. I haven't taken a grinder to it yet, as I'm not sure if that is wise. Regarding the anvil, I have worked the top and sides with a wire-brush to remove some of the rust and paint. So, if you are getting started in the world of metal work, then take the time to. This number should be the height of the face of your anvil. Make a fist and measure the distance from the floor to the bottom of your closed hand. Stand up straight and let your arms rest comfortably by your sides. For the ends you should add 1/2 inch for slop and 3 1/4 inches to overlap the two "side" 2x4s. Here is how to find the proper height: 1. You can make the sides about 1/2 inch longer than the length of your anvil/swage base. This is the height of your uprights (22 inches in my case). ago I've got two anvils on pinewood rounds right now. also HAS native white oaks, so there should be some trees in people's yards so it really wouldn't take long to find one. Unlike pine which will likely ALREADY be rotting when you pickup the log. If you want to make one, measure from the floor to your knuckles, add 2 inches to avoid hyper-extension of your elbow joint, and subtract the height of your anvil. White oak is the slowest non-tropical wood to rot. For that purpose, I made the stand hold a 12 x 9.5 inch tool. Since I have limited floor space, I might end up using the swage block in the same stand. The anvil base measures 9.25 x 11 inches, and the swage block measures 12 x 7.5 x 3.5 inches. I am not sure if I want to use the same stand for both anvil and swage block, or to make another one to support my swage block. Since I used 4x4 supports, I haven't added any metal strapping or cross-bracing to this. I also tried to keep my screws away from the edges to avoid splits. I used a carpenters square and wood clamps to hold the 2x4s in place as I screwed them on. I slanted each screw differently so it would be more stable, and put 2 screws into each end of the 2x4s. four 2x4 boards 12 3/8 inches for ends (these boards overlap the ends of the other 2x4s)Īll of the material was leftovers from building a deck - ACQ treated lumber and coated screws.four 2x4 boards 12 1/2 inches for sides (these boards are flush with the uprights).I modified the design to fit the miscellaneous lumber that I have available. I spotted a simple stand at the January 2006 Saltfork Craftsmen's meeting that I think I could build.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |